Looking at the seperator bracket you can see that two of the ports will access the outer edge of the filter while the other two ports will access the center portion of the filter.
(Before adding the 3 way valve. I had mine connected like this.)
The two that went to the center, was connected to each tank.
One of the two that would draw from the outer part of the filter was hooked to the outboard motor (via bubble) and the other port was plugged.
After adding the shutoff valve I just had an inlet (flows into the center of the filter) and an outlet (draws from the outer edge of the filter) and the other two were plugged.
Check and see if there are any instructions about this being correct or not, I normally don't read them.
__________________
'75 Cuddy with '00 Johnson Ocean Pro 150 horse
Benny
Last edited by tsubaki; 05-12-2008 at 05:49 AM.
|