[THEFERMANATOR]

Well this one is in regards to the plywood thread. The fuel tank hatch cover was cut in half by a previous owner when replacing the tank. So I had another cover that wasn't cut that needed re-coring. I am by no means a fiberglass guy, and I personally HATE fiberglass work. SO I hope I get it done half way right.

Heres the cover after cutting it apart, even HYDRA-SPORTS used the wood squares.


Here it is after taking a putty knife to it and scraping the old squares out.


All cleaned up with a grinder, and washed it up to remove any residue from the old wood glue.


The piece of wood I got from HOME DEPOT, hope it lasts.


And here it is after a layer of mat, lots of resin(man that old glass was like a sponge), and being tucked in for the night to cure.