Are you measuring to the top of the rod, or to the center of the bolt hole? Don't go cutting it just yet, the V4 and V6 loopers use the same rods. Try threading the rod out 2 turns and see if you have forward. If your measuring to the toip of the rod, you should have 22 3/16" of length from the mating base, not the rod base. There is a 1/4" of distance from the center to the top of the rod. Also try a different tape measure as a 1/4" off in a tape measure isn't much, and this measurement MUST BE EXACT!
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR
2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD 
AND THE PINK JEEP!!!! R.I.P.
http://www.wellcraftv20.com/communit...ad.php?t=11664
|