I wouldn't chance it - and I wouldn't chance Secast bonding to wood either. If you're going to leave wood in the transom (which I don't recommend), soak it well with resin and make your pour when the resin is still green. In fact, coat it once and let it set then coat it again. This should go a long way toward proper adhesion. Arjay and Nicacore pour like latex paint. From what I've seen, seacast pours like chunky vomit. I used a rubber mallet on my transom to release any air pockets, but it wasn't necessary. That stuff filled every void with ease. Make sure EVERYTHING - even the smallest hole is sealed. It will run everywhere.
__________________
FLOUNDER
|