[charlie_the_tuna]

yeah it the 3/8's fine thread.
i'm gonna pick up the new one in the morning.
i thought i got it going and when i started to tighten it down it snapped off.
everything that could go wrong today did.
taking the bolts out of the trim manifold, one snapped.
taking the hydraulic lines out of the manifold, my 3/8's combination wrench (my snap-on) broke.
mixed up some marine-tex to set some studs in the trim cylinders to hold the zincs, it never set.

i could go on and on but i hafta get up early to finish up before i dunk the piece of crap in the water.