Ok I got started and so far all is going well except replacing the shifter cable bellows. How do I get the bellows over that cable. Do I disassemble the drive end of the cable or does the engine end of the cable have to go through the bellows first?
Here's a picture of what I have at the drive end of the cable. Item #31 will not fit though the bellows
Also you can see here I've set myself up to work on this a little at a time each day after work. Rain or dark will not stop me. I'll get this done before the weekend. Also the folding ladder made a good support for the outdrive.
Spareparts, I may be calling you tommorrow.