[reelapeelin]

Bummer on the T-Nuts fallin' thru...happened to me B4, but I was able to get 'em...w/ no nut to hold 'em, just fill the hole w/4200 and seat the screw in there ... it'll look right and seal the hole ...that hatch-lid ain't goin' anywhere ;) ...


Can you tell exactly where the air-pockets are ... if so, drill 1/8th or so hole in the center of the pocket(this in the groove between non-skid), take a hypodermic syringe and inject the hole w/resin...let cure, then drill out just enough to hold some filler ... you'll never see 'em ...and the noise will go away 8) ...go enjoy the boat...ya did a good job ;) ;D ;D ;D ...


Do the above later on...take your family out and enjoy the weekend ;) ;D ...