[Blue_Runner]

I agree with all of your responses. My intent when I purchased the boat was to sell one motor and go back to the single setup with the other.

First I'm going to get the compression checked out on both engines. Next, I'm going to get rid of one of these motors and try the other one out as a single setup. If that proves to be too little hp, I'll sell that motor and buy something in the 150 - 200 range.

That brings me to my next unanswered question that I asked a good ways up in this post:

In order to hang the 25" shaft motor on this 20" transom, will I need a jack plate? I saw one that looked as if they had taken a 25" and mounted it high on the transom rather than using a jack plate - can that be done?

Thanks,
BR