Re: New Dive PlatformhAMMER
Hammer...3/8" to 1/2" roundover is all you need ... 3/4" bit on 3/4" material is too much ... if ya go that deep, you'll need a router table w/a fence to follow the edge...smaller bit w/ a roller tip will follow the edge of the material ... and look better INMHO ;) ...
__________________
'74 V-20/ BF 150
'95 V-21/ BF 150
'84 V-20/ 200 2.4 Merc
'87 V-20/'18 F150 Yamaha
|