Wellcraft V20 Community

Go Back   Wellcraft V20 Community > Search Forums
Register FAQ Community Calendar Today's Posts Search

Showing results 1 to 25 of 48
Search took 0.00 seconds.
Search: Posts Made By: Big-G
Forum: Performance 08-30-2015, 11:25 AM
Replies: 16
Views: 1,241
Posted By Big-G
Fire extinguisher

Coast Guard folks are not so diligent about fire extinguishers when it comes to their actual use. I reported a malfunctioning fire ext. which had C. C. approved markings on it and was not encouraged...
Forum: Repairs 08-08-2015, 06:01 PM
Replies: 6
Views: 214
Posted By Big-G
Great

As usual you guys are great. Thanks a bunch.

G
Forum: Repairs 08-08-2015, 04:10 PM
Replies: 6
Views: 214
Posted By Big-G
2 stroke back pressure?

Just read a post reply (TERMANATER) that discussed putting a 2 stroke in a tank and being careful about the depth of water. According to the discussion the caution relates to proper back pressure...
Forum: Repairs 08-05-2015, 02:45 PM
Replies: 5
Views: 233
Posted By Big-G
I used the ends of two bungi cords - they bend...

I used the ends of two bungi cords - they bend easyly and were available - worked great but I had to take them off after returning to the dock because I also use the bungi as tie downs in my truck...
Forum: Repairs 08-05-2015, 06:01 AM
Replies: 5
Views: 233
Posted By Big-G
Duh!

The problem once solved is simple. Thanks smoke. I went to the Bimini manufacturer's site but never used the "Bimini pin" search. I'll be ordering the pins.

G
Forum: Repairs 08-04-2015, 06:46 PM
Replies: 5
Views: 233
Posted By Big-G
Pins for Bimini?

I need two pins for my Bimini top. These pins slide through holes on the gunnel bracket to secure the metal stays. On one end of the pin is a flat locking mechanism that swivels open or close. I...
Forum: Repairs 07-19-2015, 09:50 AM
Replies: 10
Views: 302
Posted By Big-G
Schematic

The schematic shows the tube coming from under the cowling and clamped down with a clip attached to a grease fitting that may be for the steering rod encasement. Cannot follow tube (using schematic)...
Forum: Repairs 07-19-2015, 06:32 AM
Replies: 10
Views: 302
Posted By Big-G
Pees water when under way, not at idle. Pressure...

Pees water when under way, not at idle. Pressure gauge sounds right.

Thanks a bunch. Will cap it off and take her out tomorrow. You guys are great!

G
Forum: Repairs 07-18-2015, 07:23 PM
Replies: 10
Views: 302
Posted By Big-G
Found schematic of motor that shows original...

Found schematic of motor that shows original configuration (tube without crimp) and it does show a plug at the open end of the tube. This plug looks a lot like fuel connections on some of my small...
Forum: Repairs 07-18-2015, 06:33 AM
Replies: 10
Views: 302
Posted By Big-G
50 Yama front p hole tube?

My 2005 50 hp 2 stroke Yamaha (recently purchased) has a small tube extending from the front of the engine under the cowling to the inside edge of the transom. The tube has been crimped with...
Forum: Modifications 06-23-2015, 10:59 AM
Replies: 6
Views: 626
Posted By Big-G
Feel better

Thanks all! Never had a boat with this set up but evidently it is common for water to invade through the drain hole. What I did not mention is that previous owner re routed fuel line up through the...
Forum: Modifications 06-23-2015, 06:41 AM
Replies: 6
Views: 626
Posted By Big-G
Too much weight on transom?

Just purchased an old West Boats 18 footer in excellent shape but the 50hp 2 stroke Yamaha lowers the stern such that the stern deck drain hole takes in water. (Other post puts weight @ 189 lbs.) ...
Forum: Repairs 06-17-2015, 09:18 AM
Replies: 7
Views: 256
Posted By Big-G
Finished install

Just finished installing kicker bracket. Cutting access hole was uneventful but removing foam was not easy. The stuff was rigid and came out in small pieces. Was glad to see that the inside was...
Forum: Repairs 05-05-2015, 06:13 PM
Replies: 7
Views: 256
Posted By Big-G
Smile Also my initial thoughts

I had the same idea until I talked to a professional installer. Re: two 4 inch strips would work but for long term stability back plate should be one piece that matches or exceeds size of bracket...
Forum: Repairs 05-05-2015, 03:53 PM
Replies: 23
Views: 763
Posted By Big-G
I agree with you and Spare. A lot of politics...

I agree with you and Spare. A lot of politics and a lot of emotion surrounding E10. My brother just retired as a John Deere mechanic. He's on both sides of the issue: Likes the boost in farm...
Forum: Repairs 05-04-2015, 03:34 PM
Replies: 7
Views: 256
Posted By Big-G
Need 8 inch access

Thanks for the quick reply. I think I need an 8 inch access plate in order to insert a big enough back plate for the bracket. Priced a bracket at West Marine for $22.00. Concerned about the...
Forum: Repairs 05-04-2015, 07:19 AM
Replies: 7
Views: 256
Posted By Big-G
Cutting kicker bracket access hole.

Ready to install kicker bracket on old West Boat 18 footer. Stern has traditional configuration for main outboard but there are closed-in voids inboard on each side of the the engine well. Planning...
Forum: Fishing 05-04-2015, 07:02 AM
Replies: 3
Views: 162
Posted By Big-G
Right on

perfect!
Forum: Repairs 05-03-2015, 03:09 PM
Replies: 23
Views: 763
Posted By Big-G
Smile New wrinkle

Haven't cranked the Yama 50 yet but I have a 2.5 Yama that I bought several years ago for my wife's 12 ft. John boat and I just started it. It has been sitting idle in my shed for at least 2.5...
Forum: Repairs 04-24-2015, 05:28 PM
Replies: 23
Views: 763
Posted By Big-G
E-8

Sounds good. Boat in the water tomorrow.
Forum: Repairs 04-22-2015, 04:37 PM
Replies: 23
Views: 763
Posted By Big-G
Agees with local dealer

Thanks Starzo. You're advice agrees with my local Yama dealer. One question. Can you mix e-10 with regular gas? Seller put 5 gallons of non-e gas in tank before purchase.
Forum: Repairs 04-11-2015, 12:02 PM
Replies: 23
Views: 763
Posted By Big-G
10 micron

Don't know from microns but there is a water separator with recently changed filter
Forum: Repairs 04-10-2015, 08:18 PM
Replies: 23
Views: 763
Posted By Big-G
Thanks everyone

Thanks all for responses. I might start using ethanol gas with the treatment recommended. Will be trucking boat home Sunday.
Forum: Repairs 04-09-2015, 07:21 PM
Replies: 23
Views: 763
Posted By Big-G
Run carbs dry

Used to disconnect fuel line and run till out of gas on an older boat. Had a 1985 4 cylinder Merc. Still had carburetor problems. I do this with all my equipment except diesel tractor. Chain...
Forum: Repairs 04-08-2015, 04:48 PM
Replies: 23
Views: 763
Posted By Big-G
Ethanol/gas treatment/Yamaha

Bought another boat. 2005 2 stroke 50hp Yamaha. Planning on using gasoline with ethanol and treating with Stabil. Last owner advises against doing so. He also used ethanol gas with treatment but...
Showing results 1 to 25 of 48

 
Forum Jump

All times are GMT -5. The time now is 03:34 PM.


Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.