Wellcraft V20 Community

Go Back   Wellcraft V20 Community > Search Forums
Register FAQ Community Calendar Today's Posts Search

Showing results 1 to 14 of 14
Search took 0.00 seconds.
Search: Posts Made By: Hal380
Forum: General 08-01-2013, 04:48 AM
Replies: 11
Views: 405
Posted By Hal380
It must be your Karma

Hello MJ, I'm new here, but people are responding to you, not your condition.

Warm regards

Hal
Forum: Classifieds 07-30-2013, 06:51 AM
Replies: 1
Views: 172
Posted By Hal380
Newport RI Fall Vacation

Good Morning;

My wife and I own a 2 bed/2bath timeshare at the Wyndham Longwarf Resort just off Americas Cup Avenue, in Downtown Newport. The address is 5 Washington St. and is across the street...
Forum: Performance 07-15-2013, 06:05 AM
Replies: 10
Views: 406
Posted By Hal380
Unhappy Missing at slow speed

Ok problem solved - and no wise cracks please.

Decided to pull a plug to see if there were any evidence of fouling. I then noticed that not all of the plug caps were as deeply seated on the plugs...
Forum: Performance 07-09-2013, 06:37 AM
Replies: 16
Views: 1,240
Posted By Hal380
boarded by the Coast Guard

Saturday 7/6 went fishing in New Haven harbor. Was just drifting outside the channel, when all of a sudden - in the distance we could see a boat comming at us at a high rate of speed. As he got...
Forum: Performance 07-09-2013, 06:27 AM
Replies: 10
Views: 406
Posted By Hal380
More Egg on my face

I checked the year and it is a 2000. I solved the problem and things are running smoothly. I am embarrased as hell to admit it but the problem was that when I changed the plugs, 2 of the 6 plug...
Forum: Performance 07-02-2013, 04:11 PM
Replies: 10
Views: 406
Posted By Hal380
Thanks Reel

Boy do I have egg on my face - I have always said "A good answer starts with a good question" Here's the data

150EFI Mercury outboard -1990, rebuilt in 2004. Starts right up, idles well even at...
Forum: Performance 07-01-2013, 05:26 AM
Replies: 10
Views: 406
Posted By Hal380
Missing at slow speed

Just dropped my V20 in yesterday and while on a trial run noticed at low speed the engine sounds like it missing and there is some vibration. At higher speed it seems to even out. Any suggestions?
...
Forum: General 07-01-2013, 05:21 AM
Replies: 3
Views: 200
Posted By Hal380
Now in the water

I bought my Steplift from an estate. On the way home I made a safety stop to check the trailer - and found a burnt out bearing on the right tire. Had the rig towed to local dealer and bought new...
Forum: General 06-14-2013, 06:02 AM
Replies: 12
Views: 458
Posted By Hal380
I have a similar story

Though not as bad as your experience. Bought my V20 from an estate here in CT. Boat, motor - (150 Merc) and trailer for $2500. Total distance for the tow was about 45 miles. I asked the seller about...
Forum: Off Topic 06-11-2013, 05:41 AM
Replies: 26
Views: 754
Posted By Hal380
Rainbow Bridge

This is a poem which I ran across and pass it on when a friend has had to say "Goodbye to his friend", you may have seen this before, but this came to mind when I read your post.

Just this side...
Forum: General 06-09-2013, 05:08 AM
Replies: 13
Views: 401
Posted By Hal380
Thank you all

for your advise, the boat goes in this week. Still have to install a fuel/water separator, and check the tank for water. The boat sat for a year with 1/4 full tank, so I assume I have some water in...
Forum: General 06-08-2013, 06:30 PM
Replies: 13
Views: 401
Posted By Hal380
first time posting

this is a merc 150 outboard

thanks for your response

Hal
Forum: General 06-08-2013, 03:01 PM
Replies: 13
Views: 401
Posted By Hal380
Thanks Hedge

I have been roaming the forum for about a week. I made a new hatch cover from some teak I had, when I finish it I will post a pic.

Regards

Hal
Forum: General 06-08-2013, 02:19 PM
Replies: 13
Views: 401
Posted By Hal380
First time posting here

Good afternoon all;

I bought a 1982 V20 Steplift. I have been getting ready for the water and I'm almost done. Part of my "Getting Ready" deals with the motor - I would like to polish the cover a...
Showing results 1 to 14 of 14

 
Forum Jump

All times are GMT -5. The time now is 11:01 PM.


Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.