Project update
 

i know how everyone likes pictures (and so do I) so tomorow i will snap some of the v-20 tomorow. still now finished but looking better. so ya'll try not to laugh to hard at it.

look foward to the pics

:sun:

http://i295.photobucket.com/albums/m...e/DSCN1435.jpg

http://i295.photobucket.com/albums/m...e/DSCN1436.jpg

http://i295.photobucket.com/albums/m...e/DSCN1437.jpg

http://i295.photobucket.com/albums/m...e/DSCN1438.jpg

http://i295.photobucket.com/albums/m...e/DSCN1439.jpg

http://i295.photobucket.com/albums/m...e/DSCN1440.jpg

for all you e-tec fans the new 300 HP

http://i295.photobucket.com/albums/m...M2gearcase.jpg

http://i295.photobucket.com/albums/m...ce/etec300.jpg

http://i295.photobucket.com/albums/m...ce/etecinj.jpg

Looks like a nice boat!! But how were they going to drive it?? Ladder were the wheel should be??

Looks to be lots of space around that bracket?? should be bolted up tight to the transom and sealed??

But looks like you have something solid to start with!!

gives you a good idea of how much room there is in these boats, good luck with the project:clap:

naw i have a center console that i just received which will be replacing the old homemade one that was in there. and the bracket is fully enclosed so no water can get inside from the back the 4 mounting holes are sealed right now but i have to make some shims for the last two on the top so theres somting between the bracket and transom.

Let me read your future.
 

I see...........
lots of starboard.
I see............
A gas card















Dang that's nice.