Wellcraft V20 Community

Wellcraft V20 Community (https://forums.wmpdevserver1.com/community/index.php)
-   Repairs (https://forums.wmpdevserver1.com/community/forumdisplay.php?f=16)
-   -   1991 25 hp Evinrude help... (https://forums.wmpdevserver1.com/community/showthread.php?t=8011)

Airslot 04-19-2006 11:17 AM

1991 25 hp Evinrude help...
 
Hey guys. *Looking for a little input on my 91' 25 Rude for the skiff. *She runs great but won't idle just right. *I'm thinking something along the lines of a bad crankcase seal because at idle she'll sneeze, but not through the carb. *The sneeze comes from under the flywheel. *The usually happens when it stalls, or casues it to stall. *Runs like a raped ape above idle. *Any ideas? *Think I'm on the right track? *Skools....?

Edited to add...she's got a fresh rebuild on the carb and fresh gas.

Airslot

reelapeelin 04-19-2006 01:10 PM

Re: 1991 25 hp Evinrude help...
 
Gasket/seal good on the carb reinstall after rebuild?...

macojoe 04-19-2006 02:20 PM

Re: 1991 25 hp Evinrude help...
 
well its eaither gas air or eletric??

Gas should be fine if rebuilt right, Air if you have bad gasket and did you tune and replace spulgs wires coil or the points??

Airslot 04-19-2006 02:42 PM

Re: 1991 25 hp Evinrude help...
 
I guess the specific question is why is the sneeze coming from under the flywheel. When it sneezes (like a lean idle sneeze) the little puff of smoke comes from up under the flywheel. Plugs are new top plug is cleaner than the bottom plug after an hours use.

Airslot

macojoe 04-19-2006 08:41 PM

Re: 1991 25 hp Evinrude help...
 
well the points are under the fly wheel, ck them out!

Airslot 04-21-2006 10:22 AM

Re: 1991 25 hp Evinrude help...
 
Something is allowing combustuion gasses to escape under the flywheel. I'm just wondering if it could be anything other than the top seal around the crank. Come on skools, you the omc man...

Airslot

reelapeelin 04-21-2006 11:06 AM

Re: 1991 25 hp Evinrude help...
 
Good time to try this guy out...bet he can tell ya ZACKLY what's goin' on under that flywheel ;)...let us know...

http://www.wellcraftv20.com/cgi-bin/...num=1145285408

Geekie1 04-21-2006 12:13 PM

Re: 1991 25 hp Evinrude help...
 
Hi Airslot,

Try this website:

http://forums.iboats.com/cgi-bin/ubb/ultimatebb.cgi

Whenever I have a problem with my Yammie or Rude I go to this site. They have people on this site that are professional outboard techs (mostly retired) and I can say without hesitation that they know their stuff. I had an ignition problem with my 150 Yammie that would have cost me $1000+ to repair by a Yammie shop. I replaced the CDI unit myself after troubleshooting the problem (no spark) with Iboats forum help and saved me over $500!!! You need to register and then you can start asking questions. Make sure you have the make, year, model #, in your post up front. I hope this helps!!

Ed G.

Skools Out 04-21-2006 12:29 PM

Re: 1991 25 hp Evinrude help...
 
there's a ring seal for each cylinder on the crank if you are getting exhaust look for a crack in the block. how is the compression on the motor?

Airslot 04-21-2006 06:38 PM

Re: 1991 25 hp Evinrude help...
 
Thanks Skools. I haven't done a compression check because the thing runs great once it's above idle. Actually, runs as good as new. She stumbles at idle and will "sneeze" like it was lean, but not through the carb. The sneeze comes from under the flywheel. I guess I'll just pull it and take a look. I'm thinking that there is a seal along the lines of a "rear main" at the top of the block. I think this is where the sneeze is coming from. Just wondering if I'm headed in the right direction or if I'm nuts.

Thanks,

Airslot


All times are GMT -5. The time now is 09:14 PM.

Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.