Wellcraft V20 Community - Another Free Boat Story//Warning: Long

Wellcraft V20 Community (https://forums.wmpdevserver1.com/community/index.php)

- Repairs (https://forums.wmpdevserver1.com/community/forumdisplay.php?f=16)

- - Another Free Boat Story//Warning: Long (https://forums.wmpdevserver1.com/community/showthread.php?t=7871)

Another Free Boat Story//Warning: Long

I'd like to introduce myself and admit that I have been lurking (learning) since the summer. My name is Joe, I live in Northern VA, and I was given a V-20 by a family friend. Boat background = zero unless a jon boat in a freshwater lake counts. I have done frame up builds on a few old Jeeps and built my own barn, etc. so I am atleast a 'hack' when it comes to working on stuff. The boat is a 1979 v-20 I/O with an OMC 5.7 (can't I just call it a chevrolet 350 ;)). It was repowered in 1996 and not hardly used. It was stored on a trailer outside. It survived some hurricanes while sitting in the Outerbanks of NC tied to a tree. I put a new axle/springs on the trailer and pulled it home around the end of October. I have had minimal time to work on it as of yet (I have 3 kids age 6 and under and another on the way). Here is where I am with the boat: it was properly winterized, oil had no water in it, would not start because of bad starter, replaced starter and nothing. Ran out of time, came home and read OMC manual (did I mention I have all original paper work for this boat including original sales receipt and trailer manual?), as my dad and I suspected there was a neutral safety switch somewhere that was not immediately obvious. Manual shows the switch in the remote control (I call it throttle but the manual does not). Here is my question to all of you v-20 guru's.....how do you get to that switch? The way the picture shows it the thing is inside the wall of the boat. Can you get to from the cuddy or do you have to pull it out from the rod box or is is just simply there when I remove the remote control handle? The engine did turn over when I shorted starter so she is not locked up. This is a project mmy Dad and I are doing together. We built the jeeps together years ago and I am looking forward to the work on the boat and the FISHING after we get her ready for the water. Thanks for taking the time to read this and answer if you can help me out. Pictures you ask? I'll grab some over christmas and post them.