Wellcraft V20 Community
Page 1 of 2 1 2
Show 40 post(s) from this thread on one page

Wellcraft V20 Community (https://forums.wmpdevserver1.com/community/index.php)
-   Repairs (https://forums.wmpdevserver1.com/community/forumdisplay.php?f=16)
-   -   Transducer replacement (https://forums.wmpdevserver1.com/community/showthread.php?t=7772)

Mac_Attack 03-31-2007 11:29 AM
Transducer replacement
 
What would I use to fill screw holes that will be under water. I'm installing my new FF and transd and paddle wheel. thanks Billy Mac ;D

Mac_Attack 03-31-2007 11:29 AM
Transducer replacement
 
What would I use to fill screw holes that will be under water. I'm installing my new FF and transd and paddle wheel. thanks Billy Mac ;D

Mac_Attack 03-31-2007 11:29 AM
Transducer replacement
 
What would I use to fill screw holes that will be under water. I'm installing my new FF and transd and paddle wheel. thanks Billy Mac ;D

macojoe 03-31-2007 03:31 PM
Re: Transducer replacement
 
small holes like that can be done a few ways.

#1 and best way, Formula 27, fill and sand, Marine Tex will also be fine!!

#2 Take a Golf T put in resin hamer into the hole, let dry, cut end off. Great to fix screw holes in deck also!


#3. 5200 will work fine. (make sure to put 5200 on new screws)

macojoe 03-31-2007 03:31 PM
Re: Transducer replacement
 
small holes like that can be done a few ways.

#1 and best way, Formula 27, fill and sand, Marine Tex will also be fine!!

#2 Take a Golf T put in resin hamer into the hole, let dry, cut end off. Great to fix screw holes in deck also!


#3. 5200 will work fine. (make sure to put 5200 on new screws)

macojoe 03-31-2007 03:31 PM
Re: Transducer replacement
 
small holes like that can be done a few ways.

#1 and best way, Formula 27, fill and sand, Marine Tex will also be fine!!

#2 Take a Golf T put in resin hamer into the hole, let dry, cut end off. Great to fix screw holes in deck also!


#3. 5200 will work fine. (make sure to put 5200 on new screws)

Mac_Attack 03-31-2007 03:37 PM
Re: Transducer replacement
 
Formula 27 or marine tex? I have some marine tex. West marine carries F27 I assume? Thanks MJ Billy Mac ;D

macojoe 03-31-2007 04:03 PM
Re: Transducer replacement
 
use what you have!! Marine tex is perfect if thats what you have on hand!! F27 is very were Boaters world, hardware stores ect ect..

macojoe 03-31-2007 04:04 PM
Re: Transducer replacement
 
Put on as smooth as you can!! that stuff sands like Iron!!

Warner_Foster 03-31-2007 08:37 PM
Re: Transducer replacementt
 
Don't forget, immediately after applying two part epoxy such as Marine Tex, wet it (water or spit works best) and smooth out the repair to avoid lots of sanding.


All times are GMT -5. The time now is 04:34 AM.
Page 1 of 2 1 2
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.