New titlt switch installed
 

Got the new , new tilt switch installed today.

If you remember right I got one meant for a Evinrude and drilled the hole and mounted it before finding out that the used switch was junk!! *>:(

So after not finding a new switch that I wanted to pay for, I decided to get another like I got from reel.

Someone asked for a pic of the wiring?? So here it is.

Like Skools said just go to the relay box and go color for color, worked great!

I used a white wire for red here as I was out of red and I wasn't driving 6 miles to get any, I am cheap!!

http://syncboard.com/albums/Boat-Tac...dium.sized.jpg

I mounted to side of motor using the mount hole from other switch to snake wire in. then sealed the hole with some electrician's putty

http://syncboard.com/albums/Boat-Tac...dium.sized.jpg

And from 5 feet away it looks great!! *;)

http://syncboard.com/albums/Boat-Tac...290_Medium.jpg

Re: New titlt switch installed
 

Looks good from! ;D
Good job MJ!

Re: New titlt switch installed
 

mj, where did you get the will-fit switch? mine on the motor went out & merc dealer wants $60 for a replacement..

Re: New titlt switch installed
 

I bought from ebay, $18 shipped brand new in the pack!

Re: New titlt switch installed
 

Here is one for you!

http://cgi.ebay.com/ebaymotors/POWER...26859339QQrdZ1

Re: New titlt switch installed
 

Nice looking job there MJ. I have been thinking about putting one on my boat so I dont have to climb in and out to tilt the motor up.

I looked at the one you found on Ebay but the wires are to short for me. I could extend them but I'd rather have them all one piece.

Re: New titlt switch installed
 

The one I got was short also, I just added to it, they will be fine.

Re: New titlt switch installed
 

thanks mj

Re: New titlt switch installed
 

That looks good, MJ...how's the switch attached?...

Before I sent the switch to MJ, I used it on my '86 Rude ... but instead of attaching to motor, I mounted it high and inside the splashwell ... when new, there was plenty of wire to get to the junction MJ shows ... just another idea if yer thinkin' about goin' this route...either will work fine ;) ...

Re: New titlt switch installed
 

I have some super duty water proff Velcro, thats how its attachet.

They sell the switches two ways, one is like I bought with a short wire. And the other is sold as a remote switch and comes with a longer wire.

Mine came short vacum sealed from factory.