Trim & Tilt leak
 

Ok as many know I took the boat out today (See General section) and the center Oring is leaking on the ram *:'(

Now I am not looking forward to hammering out that big rusted pin, and then having to get the knuckle off, so That I can slde the cap off for a seal.

Now would something like Lucas stop leak work??

Tired of working want to be fishing!

Re: Trim & Tilt leak
 

MJ you've gone this far to make it right, don't half A$$ it now. Go ahead and fix her right and be done with it. Lucas is a band aide at best, it's also thicker than gear oil. Most all of your stop leaks use brake fluid to stop the leaks. They work by swelling the rubber, but it is a temporary fix as the swollen rubber will eventually tear and make the leak worse.

Re: Trim & Tilt leak
 

I guess you are right, I hate to admitt it!

So let me ask you, see if I get this right.

1 block the motor up

2 Knock the pin out

3 twist the knuckle off (whats the beast way to hgold the shaft??)

4 unscrew the cap and take off, replaxce center seal (leaking) and add new O ring on ther cap, reassamble.

5 top off fluid and ck for leaks.

Does that about cover it??

Thanks!

Re: Trim & Tilt leak
 

Ok the pin is so rusted that I have no idea which way in comes out??
I have playedm a bit with it and it isn't going to move with out a fight!!

But which way??

Re: Trim & Tilt leak
 

you mean the top pin or the bottom? top will go either way just like CB lol

Re: Trim & Tilt leak
 

LMFAO!!

Thanks its the top one!! I tryed for 1/2 hour today and it is not moving!

I added Fluid and it works for now! Can yiou use heat??

Re: Trim & Tilt leak
 

yeah heat and lots of Kroil but use a large hammer knock it both directions till it's loose. the pin should have been stainless. just don't mushroom it to where it won't come out.

Re: Trim & Tilt leak
 

just checking but did you take the snap rings off it yet?

Re: Trim & Tilt leak
 

lmao

Re: Trim & Tilt leak
 

No snap rings, had wire thur a hole on each end. ;D