Motor too low???
 

My motor is mounted through the top hole (lowest setting).

I almost can leave motor trimmed all the way down all the time. She pops right on plane but after plane I can pretty much leave it if there is any kind of chop but I usually trim it up just a bit. If it's flat I can trim up more and get a decent amount more speed but she'll pound easily and even porpoise at times.

I opened her up yesterday and got 5300 rpms (new tach) but only for a very short period, lots of boat traffic made it choppy. I'm pretty sure I would a couple or few hundred more rpm's if I timmed her up for a dfew more seconds, I think I'm propped right, 14x19p. 3800rpms = 32-33 mph, nice cruise:)

It seems like I should have more "trim down", could this be motor mounted too low, should I move up a hole?

Re: Motor too low???
 

Has it got good bite thru turns at speed Tin, if it doesn't you might have to go down a hole of two.
If it bites well in a turn and thru a chop the only real question is , is it low enough to let you trim the boat where you want it thru all sea conditions, if so don't change a thing.

Re: Motor too low???
 

I think I'd like to have just a bit more down trim. I know trim tabs would fix the problem, which really isn't a problem :-/ I could trim up the motor a bit then trim down with tabs. I also have a starboard list w/ both batteries being on that side so that I could fix too.

Oh, bite is fine. ;)

Re: Motor too low???
 

Tin, how far above the bottom of the boat is the anti-cavitation plate on the motor?...I'm thinkin' you should be gettin' more than 5300 outta that 200 (what is mfgr max?), but it could be motor too low or in need of re-prop...

Keepin' in mind ya gotta have fairly flat seas to really wind one up and doesn't sound like you had that :-[ ...

Re: Motor too low???
 

Max rpm is 5800 for motor and think I will be close to that on calm day and trimmed up some.

Re: Motor too low???
 

Hey Tin just get a set of 5* motor wedges. will fix your problem. i had a set on my v20 to fix the same issue.

http://cgi.ebay.com/ebaymotors/OUTBO...spagenameZWD1V

http://i13.ebayimg.com/02/i/07/55/28/49_1_b.JPG

Re: Motor too low???
 

Interesting mod - never seen those, but what a great idea!

Re: Motor too low???
 

Thanks skools...I bet that'll do it.

Re: Motor too low???
 

i have a set if you want a better pic fixed my v20 and sea ox

Re: Motor too low???
 

what hp motor do you have
if its a 150 go with a 14/17