Wellcraft V20 Community

Wellcraft V20 Community (https://forums.wmpdevserver1.com/community/index.php)
-   Performance (https://forums.wmpdevserver1.com/community/forumdisplay.php?f=15)
-   -   4500 rpms is all shes do (https://forums.wmpdevserver1.com/community/showthread.php?t=7366)

el_pescador 03-24-2007 07:12 PM

4500 rpms is all shes do
 
hi everyone i bought this 1994 cc 20 wellcraft with a 1994 150 yamaha did not water test ran only with earmuff and it sounded great 1st lake run about 4500 rpms with 15x17 prop could trim out to 4800 but bow was really bouncing . i changed props to 15x 15 same e xact thing no change what so ever . the throttle opens the carbs. fullly open at 3/4 throttle and no increase at full throttle. i checked coils to the sparks plugs it has a blue spark on all plugs the plugs appear to be black and a little oily with only 3 lake trips and a half dozen earmuff flushing. the motor idles perfect compression on all cylinders around 118 with no leakdown, good out of hole shot ,run find other than what i stated , my specs. for this motor states rpm range 4500-5500- my prop man believes it should top out closer to 5500 with on 1 person aboard, can anyone clue me in on what i maybe missing here before i take her to a yamaha service dept. i never had a yamaha but have had other motor and in pass full throttles u got max. rpm there thanks

macojoe 03-24-2007 07:30 PM

Re: 4500 rpms is all shes do
 
Have you checked that the throttle is opening alll the way?? *
Might need a cable adjustment?
Decarb the carbs??
Add new plugs??
How old is the gas?
Have you changed the filter?? *
How about the tac, are you sure its reading right??

THEFERMANATOR 03-24-2007 09:44 PM

Re: 4500 rpms is all shes do
 
Will it rev higher in neutral?

spareparts 03-24-2007 10:16 PM

Re: 4500 rpms is all shes do
 
last time i chased down an rpm problem on a Yamaha, I asked around, ebveryone told me Yamaha's never have an ignition problem, after going thru the carbs three times, four set of plugs, rebuilding the fuel pump, guess what, it was an ignition problem, teh stator was not producing enough spark at higher rpms. I used a spark checker on all six wires, opened the gap to beyond 8mm(yamaha spec), found the spark becoming irratic, checked the coil output witha dva meter, found the stator was going bad, replaced it never had any more problems

charlie_the_tuna 03-25-2007 12:12 AM

Re: 4500 rpms is all shes do
 
you have a prop man?

i want a prop man.

anybody know a good prop man i could have?

willy 03-25-2007 02:19 AM

Re: 4500 rpms is all shes do
 
I'll be your prop man CTT. Just as long as you keep smiling ;D

el_pescador 03-25-2007 12:24 PM

Re: 4500 rpms is all shes do
 
spareparts whats the voltage u need at the coil and whats a dva meter is that a digital volt meter. thanks

spareparts 03-25-2007 11:26 PM

Re: 4500 rpms is all shes do
 
try this
http://rapair.com/index.php?option=c...&Itemid=34

let me know what model engine you have and I'll get you the yamaha output spec

el_pescador 03-26-2007 11:32 AM

Re: 4500 rpms is all shes do
 
1994 150 saltwater seris model 150txrs thanks

spareparts 03-26-2007 12:49 PM

Re: 4500 rpms is all shes do
 
pulser coil
resistance 320ohm
peak voltage loaded 2
peak voltage unloaded 2.5
peak voltage @1500 rpm 9.5

low speed charge coil
resistance 740ohms
peak voltage unloaded140
peakvotage loaded145
peak voltage @1500 170

high speed coils
resistance 69 ohm
peak unloaded 40
peak loaded 40
peak @1500 170
cdi output
peak loaded 105
peak @1500 140

ignition coil
secondary resistence 3.8kohms
spark plug boot
resistence 5.0 kohm +- 1 kohm

read thru the rapair trouble shooting guide, you will need a dva meter( explained ont he rapir site)


All times are GMT -5. The time now is 08:59 PM.

Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.