Engine Stand???
 

I am going to pick up my new used Suzuki 140 today. The only problem is that my old Yamaha 200HP engine is still on the boat. I want to set it up so I can still start it up for when I sell it and someone comes to check it out.

Any suggestions on an engine stand? Is it possible to make one?

Thanks!!!

Re: Engine Stand???
 

PC

Here is a link to a past thread about this subject.

Also, when you see the one I built, just note that I shortened it and added cross members across the middle for added support.

http://www.wellcraftv20.com/cgi-bin/...96041;start=15

Re: Engine Stand???
 

BG, that post was WAY too informative, helpful and straight to the point. You have eliminated the need for and further posting in this thread thereby preventing a PILE of BS slinging. :-/


Have you learned nothing from being around here young Jedi? ::)

Re: Engine Stand???
 

Don't forget the lifting ring (eye) if either of them don't have them on the motor (saves a lot of grief).
Not sure check Harbor Freight they might have one big enough.

Re: Engine Stand???
 

Or you cant just wrap a big tow strap around it like so:




http://www.forumpictureprocessor.com...052706_003.jpg


;D

Re: Engine Stand???
 

I did the tow strap thing and I ran a 2 x 10 across a opening on my deck to hold my motor.

Re: Engine Stand???
 

i just use a flywheel hanger i made for my motors and you can put an outboard on the cheap motor stands avail from like autozone or advance just adjust the motor holders to fit an outboard.