update
 

This weekend I got out in the nice weather and did some more work. I swapped out the lounge for a Todd model 1000 seat/pedastel and swapped out the capts chair with the same. I then installed a hatch in the transom bulkhead where the old rotted teak doors were.

I also took the bow pulpit off and resealed/re-bolted it down. It was leaking a bit into the cabin.

I'll hopefully get some pics soon.

Re: update
 

I also installed the Todd 1000's. They look great and there's plenty of room to get through

Re: update
 

Considered those same seats recently...either had to replace seats or reupholster existing....wound up goin' to trim shop....seats look a little close, but nobody's complained and gawd knows they would ::) ....

Post pics, man we gotta see 'em... ;D

Re: update
 

Here ya go...

The two new Todd 1000's:

http://img.photobucket.com/albums/v3...1/DSCF0096.jpg


The rear bulkhead hatch -damn I have alot of screw holes to fill- any advice?

http://img.photobucket.com/albums/v3...1/DSCF0099.jpg

And I found a replacement hatch door for the tackle locker:

http://img.photobucket.com/albums/v3...1/DSCF0098.jpg

Next, I may cover the port dash area with starboard and replace the teak strips (removed in the pics) with starboard. Its easier to cover then to fill /sand etc. I still have lots to do.

Re: update
 

If I didn't know any better, it looks like you took a picture of my boat seats. Great job.

Re: update
 

Hey Fillet...LOOKIN' GOOD, MAN 8)...like that deep drawer in that tackle box....you're fixin' to launch a nice V20.... :)

Re: update
 

She's coming along nicely! ;D

Re: update
 

Thanks.

I am dying to get the cover off completely so that I can do some gel coat repair and fill the screw holes. I'll probably have to wait until it warms up to get to it, or the gel/filler/ epoxy wont cure properly.

I still have lots to do. Right now my short list is:

1. Clean up the wiring in the cabin - There is no cover for the rear of the helm, and the wiring, while new, is a mess. Plus, the running lights were re-wired by the p.o. and the wires just drop down onto the "shelf" inside the cabin. I dont really know what to do with that yet. Apparently the old wire was under the carpet??

2. Make a cover for the well in the cuddy. - probably out of marine ply.

3. Fix/re-route raw water washdown system.

Re: update
 

If it's in the budget, Starboard (3/4") would make a real nice cover for that hatch in the cabin ;D...you'll NEVER have to replace it...

Re: update
 

All right Mr. Productive nice boat, what are those channel locks doing holding up your cover support? huh, huh..... ;D