Window frame mounting
 

Does anyone know how to access the screws (?) that hold down the lower edge of the window frames on the foredeck? On the helm side the frame is loose and comes up off the deck if pushed. Not alot, but enough to let water in. I would like to re-screw it down if I could.

Re: Window frame mounting
 

Sometimes if there's not a way, you gotta MAKE a way...fire up the chainsaw, Lukey... ;D...I love the smell of fresh sawn fiberglass in the morning... :D

Re: Window frame mounting
 

on my 85 there is a black plastic removable strip on the lower bar of the lower bar.an all the screws are under neeth,i did that repair an through bolted both sides.i used longer screws an lock nuts,an after every thing was tight,i'd grab the long end of the screw with plyers an bend back an forth till the snap off flush an clean with the nuts.

Re: Window frame mounting
 

Jaysea -

Are you saying that you removed the glass from the frame and accessed the screws from there? The black plasic strip is the rubber holding the glass in place?? Or were you getting at it from inside the cabin???

Re: Window frame mounting
 

dont take the glass out. on my boat, on the outside,the lower piece of aluminum has a black strip made of plastic or rubber,i removed that piece, under there were all the screws,some were broken some were loose,hope this helps,it was an easy task i did both sides

Re: Window frame mounting
 

Thanks, i'll take a look at mine whn I get a chance!! :)