Bow Pulpit
 

fillet 1 I'm here looking at your bow set up again and really envy it *Please post close up photos when you can Thanks Bill Mc ;D

Does the pulpit interfere with the sliding hatch? *

Re: Bow Pulpit
 

Mac,

I dont have any pics yet. I'll get you one when I get the cover off again.

It doesnt interfere with the hatch at all. Its a solid pc of teak about 2 inches thick. Its Thru bolted with ss carriage bolts. It has a Good roller assy. The rode drops down into the cuddy through a hawse fitting with cap. Inside the cuddy the "shelf" area has a hole in it for the rode to drop down in to the anchor locker area.

Re: Bow Pulpit
 

Hmmm ... I wonder if I can make out of Starboard?? two 3/4 pieces is 1 1/2 thick?? That would be nice!!

Yea Pic's baby!

Re: Bow Pulpit
 

Thanks for your reply fillet1. I'll be waiting for those photos! MJ starboards not a bad idea either except nothing bonds the two pieces together except bolts. Give me more ideas! Thanks Bill mc ;D

Re: Bow Pulpit
 

wait to see close up pic's. Then I will get the old rusty mind going on what to do.
Between us we may come up with Greatness! ;D

Re: Bow Pulpit
 

This has been on my mind all winter. Do we need a pulpit or could we get away with a Windline URM-1,2,3,4 type setup?

Airslot

Re: Bow Pulpit
 

Airslot I'm not familiar with that setup, enlighten me please? bill Mc ;D

Re: Bow Pulpit
 

Windline makes anchor rollers. If you do a yahoo or google for Windline URM you will see them.

Airslot

Re: Bow Pulpit
 

My buddy has the Windline setup on his V20. Works out pretty good. Pics in my gallery at the end.

MJ, who says the Starboard needs to be glued? Two layers, countersink some holes on top, counterbore underneath for the nuts and through bolt with stainless hardware. Cut the slot, fit a Windline pulpit roller. Router all the edges and attach to boat with through bolts and backing plate. Done! Lets do it.

Re: Bow Pulpit
 

Ok come up tomorrow!!

Really I want to do it and I have the starboard all ready!
I am also going to need your help with the floor in my boat. I am going tomorrow to see the LineX guy to see how much it will cost to do the deck, and what I have to do for prep work.
But I need to fix that crack were the engin cover screws to and you had a couple of Ideas for that.
So lets see what the guy says, and see what i need to buy for the Anchor thing and let me get it all toghter and then we can plan a day to best use are time to get the most work done!! I don't want you to have to come here more then you have to!!
Thanks Bud!!