Wellcraft V20 Community

Wellcraft V20 Community (https://forums.wmpdevserver1.com/community/index.php)
-   General (https://forums.wmpdevserver1.com/community/forumdisplay.php?f=10)
-   -   Motor Question (https://forums.wmpdevserver1.com/community/showthread.php?t=4277)

fillet1 06-04-2005 04:19 PM

Motor Question
 
I have a 1999 Johnson Ocean pro. 150 ish hours. New plugs and impeller this year. Compression in each cyl checked out perfect.

I've had about 8 trips out so far this year. The motor was winding up to 5500 rpms at wot. Last two trips wot is 5000.

Motor always started cold on first blip of the key. It has the F.A.S.T. system that keeps rpm up until engine warms and can idle normally.

Recently, the motor starts right up cold, but idles a bit then stalls. It starts right back up and then I have no probs.

The motor seems to be running a little rough. Not much, but I notice the difference.

I drained the water separator and got alittle water.

Any Ideas for me?

macojoe 06-05-2005 10:42 AM

Re: Motor Question
 
try decarbing it?? If the carbin has started to build it will run a bit off!! I have to do my Yammy at least 1 time a year to keep it good!!

When weree the plugs changed last?? Fuel filter been changed, Both on the motor and the line? fuel restriction??


All times are GMT -5. The time now is 12:21 AM.

Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.