Fuel tank section drainage
 

Does the section below the floor that holds the fuel tank have any drainage? I opened up the hatch that covers the fuel tank and found some old moldy water sitting on top of the tank. This water obviously leaked through the joint between the hatch and the floor, but why would it stay there? Could it be that the drainage channel was foamed in when the tank was installed or reinstalled?

Does anyone have any ideas for modifictions to solve this problem? Unfortunately, the water is always going to get in there because, in my opinion, this cover was poorly designed by Wellcraft.

Re: Fuel tank section drainage
 

Cliff, I'd put that cover back down and do a better job than Wellcraft w/ some 4200 sealin' it back up...don't forget Franco's trick w/ the mono line... ;)...

Re: Fuel tank section drainage
 

There was someone here who said that the drain was a poor set up.

He made a nice platform under the new tank which left pleanty of room for drainage to the bildge.

I wish I could rember who it was, or at least the thread? I try finding it?

Re: Fuel tank section drainage
 

Sounds more like Clifff's problem is H2o on top OF THE TANK...are stringers, foam, etc. forming a dam around the edge of the tank?...if so, can an outlet be cut ouuta the back to allow it to drain?...you'd wanna glass the new-cut surfaces so rot doesn't set in there... ;)...

Re: Fuel tank section drainage
 

I pulled my tank cover up last year. I ran a very generous bead of GE Silicone II caulk that filled the channel where the deck piece sits and screwed back down, problem solved. The silicone came in gray which was the same color as my deck.

Airslot

Re: Fuel tank section drainage
 

MJ, the thread about the poor drain setup was Stinky's. Pictures are in his gallery. Where has Stinky been anyway?

Re: Fuel tank section drainage
 

Yes, the water is on top of the tank because there is foam all around the edges that creates a reservoir. What I guess I'm trying to figure out, is if cutting away some the foam to create a channel for the water will do any good. Without lifting the tank I can't tell if there is a drain underneath it or not. If there is, where is it located?

I agree that I'll have to use silicone to seal up the hatch, but I'm amazed that this should have to be done to a boat that seems to be so well designed otherwise.

Re: Fuel tank section drainage
 

well its a 26 year old boat, nothing stays sealed forever!!

Re: Fuel tank section drainage
 

Did they come from the factory sealed with silicone?

Re: Fuel tank section drainage
 

I doubt they used silicone...more likely a marine grade sealant w/ low adheasive qualities...just like 3M 4200, which is what you oughta use to put 'er back ;)....