ROD HOLDERS?
 

IM LOOKING AT THE GUNWALES AND IT DOESNT LOOK LIKE THERE IS MUCH ROOM FOR FLUSH MOUNT ROD HOLDERS... WHAT DO YOU GUYS DO?

Re: ROD HOLDERS?
 

Fishmaster mine is a cc and it has 6 flush mounts with no prblems

Re: ROD HOLDERS?
 

Hey Fish, look in my gallery. I found some short tube rod holders @ marine connection. I am assuming you meant it wasn;t deep enough above the rod boxes to mount standard rod holders

Re: ROD HOLDERS?
 

I have a buddy with an '83 V20 that cut the tops of the rod boxes with a hole saw to allow the rod holder to extend down. It really only intrudes a few inches into the top of the rod box and is negligable IMO.

Re: ROD HOLDERS?
 

franco, i was actually refering to the width of the top of the gunwale... looks to be about 3.5 inches wide at best.


<*{{{>(

Re: ROD HOLDERS?
 

CB,

Mine are done the same and they work just fine.

Re: ROD HOLDERS?
 

"measure 2x, cut once"

Re: ROD HOLDERS?
 

you have a steplift and you say theres not enought room at top? I dont think so. its a fishing machine look again and i have 4 flush mount roc holders and 2 out riggers plenty of room
i own a 1978

Re: ROD HOLDERS?
 

Sorry phester but i disagree with you on this one
CUT ONCE BUT MEASURE 3 TIMES ;D

Re: ROD HOLDERS?
 

Didn't have problem locating rod holders here...
http://i3.photobucket.com/albums/y90...n/P4210004.jpg
Sorry about the dirty boat pictures...