Question on mounting the swim platform
 

My new (used) poly swim platform with three step ladder came in yesterday (thank you ebay). As I don't have any install instructions, can someone give me a rule of thumb on mounting height? Also, are these things mounted with through transom bolts or just screws?

Thanks,
Maury

Re: Question on mounting the swim platform
 

On a duallie you should have easy access to the transom, I would definetly bolt it. I would'nt trust screws holding my 220 lbs coming out of the water.

Re: Question on mounting the swim platform
 

Yes, bolt on.
If it's the standard type, just put to the boat and see where it's comfortable to drill and bolt at the highest and lowest location. Chances are you only got 6" travel possible without interfering with the lift ring.

Re: Question on mounting the swim platform
 

Some have bolted the top, and screwedm the bottom. Use nice backing plate for the thur bolt and lots of 5200 on all!!

Re: Question on mounting the swim platform
 

THRU-BOLT w/a HEFTY backing-plate on top bolts...thats where a LOTTA pull will take place, whereas the lower fasteners will have a shear load on 'em ... MJ's right about have lots of 5200 on hand ;) ...

Re: Question on mounting the swim platform
 

Also get a good eyeball on where it will sit when you are moving, you don't want it into the water more than needed.

Re: Question on mounting the swim platform
 

Hey flounder, is this one of those Bayliner swim platforms
I have been seeing on e-bay?

Re: Question on mounting the swim platform
 

Used poly platform with three step ladder
http://i5.photobucket.com/albums/y19...na/ladder2.jpg

http://i5.photobucket.com/albums/y19...na/ladder1.jpg

Re: Question on mounting the swim platform
 

Nope not one of the Bayliner platforms. ;D

That one is better. ;) ;)

Re: Question on mounting the swim platform
 

Have you decide which side to mount it on?
I'm sure that you can change the bracket to mount on the port side so you won't have to climb over the control and steering cables.
I didn't see the lower support, I presume it came with it?