Transducer mount.
 

Does anyone have any pics of where they mounted there transducer? If you do can you post it thanks

Phatdaddy i see you epoxied that plastic but did you also screw it in to? I asked because mine is under the drain hole tube and the water that drained landed on the transducer and kind of screwed it up

What epoxy did you use?

lookup "stern pad" on amazon or ebay

Not screwed into transom. Piece of 1/2 starboard is held on by epoxy (gflex by West) only. The transducer is screwed into the starboard , but not into the transom.

It is a homemade stern pad like skunk mentioned.

It***8217;s

Ok thanks stern pad got it thanks again, I really don't like drilling holes below the water line

You can get a gflex kit for about the same as the stern pad kit. I had the starboard left over other projects.

That's where mine is located too..

Do you think yours is stronger,better than the stern pad ? The reason is I would really like something permanent and what would you use to fill the screw holes I have now below the water line