square trim motor
 

i want to remove my power trim motor, there are two screws that i removed ,so it should lift right out right noooooooo it is solid in there no movement at all, i did have it replaced about two years ago so its not stuck but it dontr come out is there some thing im not doing right? its the square motor from a 1988 150 merc trim assembly

its at least three screws if not four

i will look again but i only see 2 but what your saying makes sense

you are right 4 screws on top of the motor
took the motor off and it was loadedwith oil then took the plate off that the motor is on and the rubber seal came off with the plate so now how do i get the bottom out the piece that the motor sits on so i can replace all the seals thats the question