Kicker motor to main steering connector
 

I am rigging the G3 and want to tie the steering from my main motor (yamaha F60) to my 9.9 Kicker motor (tiller model)
Any of you guys use any of these tie rods or similar set ups? Any suggestions?

Also thinking about picking up a 4-stroke Yamaha kicker, anyone know any good deals on one? 9.9 Tiller 20" shaft electric start preferred.

I had that setup on my Grady with the tie rod connector between the Evinrude 225 and my Yamaha 9.9
The Yammi was four stroke so all I had to do was install a Tee valve off the main tank. Steering from the helm console make things a whole lot easier.

I already have the fuel and electrical hook up on the G Spot with my 9.9 Suzuki. Right now I steer it with the tiller sitting in the back . Which tie rod set up did you use?

I think this is the link
http://www.wellcraftv20.com/communit...icker+steering