Wanted - Electronics Bracket/Mount
 

I need an aluminum bracket to mount a used VHF radio I just bought. The mount I need has 7" to 7-3/4" between the yolk ears and needs to be at least about 3-1/2" high to the mount knob screws. My boat is used in saltwater so steel won't do.

Re: Wanted - Electronics Bracket/Mount
 

Geek, go to Home Lowes Depot and get some flat alum. stock...clamp 1'' in a vise and start bend by hand, finish w/ block and hammer til ya get a good 90* bend...cut to fit and smooth corners and edges w/ a fine file...put two holes in short-end for attaching to boat and one to mount the radio on the long-end for the radio screws...paint or not: you're good to go...take your time, you'll be amazed ;) ;D ...

Re: Wanted - Electronics Bracket/Mount
 

Sound like a plan right there ;) Custom!

Re: Wanted - Electronics Bracket/Mount
 

Good advice RAP. I've done it in the past. ;)

Re: Wanted - Electronics Bracket/Mount
 

Hell, just sneal into the wife's purse and grab her credit card and go out and buy a custom one. She wont noticed it on the credit card bill. ;D ;D ;D ;D ;D ;D

Re: Wanted - Electronics Bracket/Mount
 

I like Hammer's idea better than mine... ;D ...

Re: Wanted - Electronics Bracket/Mount
 

I've tried that method also with less than favorable results. :'(

Re: Wanted - Electronics Bracket/Mount
 

Thats cause you allow her to pay the bills!!

You mange the bills and they never see! ;)

Re: Wanted - Electronics Bracket/Mount
 

Well oh wise sage, I do pay the bills. She gets to the mail before I do though. >:(

Re: Wanted - Electronics Bracket/Mount
 

Get a dam PO box!!