Wellcraft V20 Community

Wellcraft V20 Community (https://forums.wmpdevserver1.com/community/index.php)
-   Performance (https://forums.wmpdevserver1.com/community/forumdisplay.php?f=15)
-   -   Another " how fast " discussion (https://forums.wmpdevserver1.com/community/showthread.php?t=17553)

bgreene 05-03-2012 08:16 PM

Another " how fast " discussion
 
Probably won't get answers to this one..........

Anyone running a V or V21 with a newer Merc Optimax 225 ?

No, I'm not buying an Opti. I believe the Opti 225 may provide the greatest top end speed of all 2 stroke outboards, so this may the " maximum" power outboard to rig to a V.
There are larger, but not within the hp rated spec.

I'm guessing 55 mph WOT based on report of 200 HO Etec V21 hitting 52mph.

THEFERMANATOR 05-03-2012 09:49 PM

Ridgerunner has a 250 OPTI on his V-20 center console.

Redneck 05-04-2012 08:35 AM

I run a 200 Yamaha 2 stroke on my V21 and get 48-49M WOT. With two men and a boat load of gear and ice. Wounder if I could hook up a Nitro bottle to her :head::head:

Redneck 05-04-2012 08:38 AM

Quote:

Originally Posted by barnegatV20 (Post 188609)

Might be over kill but I just ordered two for the back end of the V. Now to fab a motor bracket for them.:cen: I want one!!!!!

THEFERMANATOR 05-04-2012 11:16 AM

Quote:

Originally Posted by Redneck (Post 188643)
Might be over kill but I just ordered two for the back end of the V. Now to fab a motor bracket for them.:cen: I want one!!!!!


Make sure it is a mega flotation bracket as those babies weigh over a thousand pounds a piece.

jasoncooperpcola 05-04-2012 11:27 AM

I think it also depends on wether the 225 Optimax is a carb or fuel injected. I beleive the carb models offer more speed but the fuel injected model offers much better fuel efficiency but a lower top end. I do not know what the 225 Ridge took off was. But when he went to the 250 he reported a little bit lower top end. If my sponson and bracket idea works i will be hanging a 225 carbed Opti on my V20 after the rebuild.

RidgeRunner 05-04-2012 02:22 PM

Took off a 250 EFI weight of 465 lbs (No oil tank, oil injection removed. I believe it was a stock motor but came from a guy that builds hot rods. It has balls.)

Bolted on a 250XS Optimax advertised dry weight lightest model of 505 lbs (add 3 gallon oil tank to the stern full of oil plus the extra 5" of length in the mid stepping up from the lightest short shaft model to the 25") I would call it closer to 550 lbs in reality.

Dropped 5 mph (down to 58 from 63). But I did get some of it back with a slight working of the prop. Now it will do 60 when light and aired out. All around mileage is about 5MPG best as I can tell. I like top end, I love the 40-50 MPH cruising speed. The ability to tow another 20' boat on plane with the additional hp is cool but near useless most of the time. The sternheavy feeling of having the 40 gallon baitwell full of greenies with three people on board, not so cool.

The EFI's suck the fuel like no tomorrow. So do the carb motors. Was getting around 2 MPG if lucky with the 250 EFI.
All Optimax motors are direct injected with a seventh piston (the one in the compressor that provides the air for complete fuel atomization directly into the combustion chamber. Another thing about the XS Opti versions, some are limited at 6100 rpm and some are limited to 5800 like a stock Opti. I have the latter. Every now and then when I push it hard I will get an alarm for overspeed at 5900 rpm. Fist time it happened was an eye opener.

I think the 3.0L Optimax motors are great, provided your rig can handle the weight. The 225 Opti on the Whaler was a fine motor. Adequate for most, twin 150's would have been ideal although more costly to own and I am not sure 1x150hp engine would have put it on plane without a prop change.

As for the 225 Optimax and rated hp. I think the 1983 was only rated for 200 hp. The v-20 was definitely not intended for motors woth so much hp torque or weight. The way the transom was designed and how the stringers were cut down at the transom it was never intended for setback brackets and big hp. They designed them for the hp de jour.
Love hp threads.. Thanks Bgreene.

bgreene 05-04-2012 03:51 PM

I think that cruise ability at 40 - 50 mph is fantastic.

My V21 tops out at 40 with the 150 hp Evinrude.
Adaquate, especially considering most of the conditions I boat in don't allow higher speed cruising. The typical " calm" ocean around here ........... 25mph is a very respectible cruising speed, and comfortable.

That plus I don't beat the C out of my boat.

bgreene 05-13-2012 06:08 AM

Funny - where I fish, " how fast " doesn't matter because the ocean is rerely calm enough for comfortable cruising over 30 mph.


The " sweet spot " on a calm ocean day is more like 25 mph !!

It's you lake guys that can really mess with top end once and a while.

tartuffe 05-13-2012 12:50 PM

I have a 200 Rude on the back and can only get around 38 MPH at WOT but mind you when I punch it I come straight out of the water like a trident missle.

But yeah, I gots issues, prop issues. Plan to rectify that this year.


All times are GMT -5. The time now is 03:43 AM.

Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.