any way to use a 20" shaft motor on a bracket that requires a 25" shaft motor?
 

I am curious if theres any way to use a 20" shaft motor on my gill bracket that requires a 25" shaft motor.. Any kind of jack plate that lowers? Lots of 20" shaft motors around me cheap, but not a lot of 25"s in my price range.

On my 21 I used a 6" set-back manual jack-plate and it works, but I would NOT suggest using one on a bracket...recalling several past attempts at that, it buries the engine in the wake when the boat comes off plane to slow down...I wouldn't do it...sorry man...bust out a few more bucks and go for the 25"er...

Thanks man. That makes sense. Seems like a few 25's popping up now too.

I had a 25 on my V20 always wished I could have had a 30 just to stay out of the water some, no think a 20 is a good Idea

Is there any way to use a 30? There is one for sale near me here for a decent price...

You can do what I did I have a 20 inch transom I ran a Jackplate all the way up for the extra 5 inches and I run a 25 inch motor.........

http://i15.photobucket.com/albums/a3...R_0011_1-1.jpg

Same way if you have a 25 shaft and want to run a 30' jackplate

I used one of these....
 

http://www.baymfg.com/

5 inch extension for your foot. Works very well. I went from a 20 to 25 on a bracket.

The website is quite lacking as far as pics and info are concerned. Can you give us some details including cost?

Thanks,
Curt

The Bay Kit includes a

5" Shift Shaft Extension
5" Drive Shaft Extension
5" Water Tube Extension

5" Aluminum Housing (Spacer)
Longer Studs


I've used several of these kits on Motors before and they work well. The kits are $600+ . . . You can save some $$$ by finding pieces on ebay.