Wellcraft V20 Community - New Swim Platform

Last time we had just gotten thru installing trim tabs...posed a problem w/the swim platform...when dismantling there's always one bolt that won't come out...
http://i3.photobucket.com/albums/y90...latform002.jpg
Drilled a small slot in the edge, just enough to stop it...
http://i3.photobucket.com/albums/y90...latform001.jpg
That done I figured the best way to go was to reinstall the frame...
http://i3.photobucket.com/albums/y90...latform001.jpg
http://i3.photobucket.com/albums/y90...latform008.jpg
Here's the raw piece...gonna take a little whittlin'...
http://i3.photobucket.com/albums/y90...latform011.jpg
Got the 3 pieces cut, now clearance for the tab-cylinder...
http://i3.photobucket.com/albums/y90...latform011.jpg
Line up the 3 pieces...
http://i3.photobucket.com/albums/y90...latform037.jpg
Startin' to take shape...
http://i3.photobucket.com/albums/y90...latform038.jpg
OK...after several passes w/the router (3 different bits) and some screw-holes...bolt on the side handle on the right to help the old fat-boy outta the water...
http://i3.photobucket.com/albums/y90...latform041.jpg
She's DONE...Starboard to the rescue again...
http://i3.photobucket.com/albums/y90...latform044.jpg

OK...ready to haul it down to Sunset Beach tomorrow for Spring Break...hope for some pics to share w/you guys when we get back...

RB...you gonna be down that neck of the woods any next week?...

Sorry about double posting some of the pics...will try to do better next time...thought about it, but decided against reaming out a slot in the original, so found this piece of 1" Starboard left over from a recent project...