steplift performance w/150 yamaha 4 stroke
 

Anybody have this setup and know mpg/basic performance etc.also are controlls for four stroke model year 2004 useable with a two stroke?
thanks,Ray

Ray,

I'm pretty happy w/the overall performance of my Honda 150...have had it since '04...a little heavier than my '74 likes (which is why I'm anxious to try out trim tabs I've just added) and it isn't as strong outta the hole as the gas-suckin' rude 150 2-stroker that used to be on it...

What I DO like about it is it starts and runs flawlessly EVERYTIME and although I didn't have numbers (GPH, etc) I can tell ya I'm using CONSIDERABLY less gas than before...tops out at 42 MPH and cruises at 30-32 MPH...used to be I didn't leave the dock w/out toppin' off...now I'll run 3-4 trips before gassin' up...

Franco has a 150 Yam 4-stroke on his 20' CC and is happy w/his...hopefully he'll chime in here...

I had to put off repowering this year since I built a shop and have plans for replacing my floor and repairing/replacing my stringers. I am definitely going with the f-150 and I am figuring an average of 4 mpg.

You can use these to get a good idea of what it will do, just find a test with a boat of similar size and hull design as you V and you will be pretty close.
http://www.yamaha-motor.com/outboard.../perfbull.aspx

i wouldnt expect an awesome holeshot.

If I had it to do over...it'd be an E Tech...which was not available in this HP range when I needed a motor...even more so now they've been out for a few years and proven themselves...

they are nice motors, but make sure you have a dealer that knows what they are doing with them.

In 07 we repowered with an Etec 150. Couldn't be more pleased. The top end we acheived was 46MPH at 5100 Rs with a stainless prop. Lumber has a 200HP Etec which is the same as the 150 with some computer adjustments. Just as cterrebonne says make sure your dealer knows what he's doing with the Etec. Billy Mac

W/two in college, it ain't gonna happen anytime soon, but I have an EXCELLENT Etech dealer...he's my HONDA dealer!!...and a large part of the reason I bought the Honda at the time...ya'll wouldn't believe this guy...everybody should have a dealer as good as Holden Marine...:love:

Reel your are right that is why I said we repowered. I couldn't affoed it by my self so my father in law and brother in law are my partners on the motor. My ETEC dealer is the oldest Johnson dealer in Michigan. I research my options and one dealer was within two miles from my house. He did not know any thing about the digital dash. That is why I chose Lockemans.



Yes I know Evinrude and not Johnson makes The ETEC!