heres a question
 

When I pulled my boat out couple weeks ago I notice that when we took the plug out , the whole threaded part started to spin before the plug came loose ...... I know its something that will have to be addressed when we soda blast the bottom.....has anyone else run across this problem?????

heres a question
 

When I pulled my boat out couple weeks ago I notice that when we took the plug out , the whole threaded part started to spin before the plug came loose ...... I know its something that will have to be addressed when we soda blast the bottom.....has anyone else run across this problem?????

Re: heres a question
 

first signs of water intrusion, remove the plug assembly, let it dry out good, reinstall with Life Caulk, rotate the garboard plug so you have new places for the screws to bite

Re: heres a question
 

first signs of water intrusion, remove the plug assembly, let it dry out good, reinstall with Life Caulk, rotate the garboard plug so you have new places for the screws to bite

Re: heres a question
 

thanks spare....................

Re: heres a question
 

thanks spare....................

Re: heres a question
 

Wish mine had come w/ a screw-in plug... ::) ... ;D ;D ...

Re: heres a question
 

Wish mine had come w/ a screw-in plug... ::) ... ;D ;D ...

Re: heres a question
 

reel what types your boat have?

Re: heres a question
 

reel what types your boat have?

Re: heres a question
 

Heck, Slinger...my old gal was laid up B4 screw-in plugs were probably invented... ::) ... it's got one of the rubber exspansion plugs that screws into a copper sleeve...
:D ...

Re: heres a question
 

Heck, Slinger...my old gal was laid up B4 screw-in plugs were probably invented... ::) ... it's got one of the rubber exspansion plugs that screws into a copper sleeve...
:D ...

Re: heres a question
 

Thats a easy fix rap!! Just change over

Re: heres a question
 

Thats a easy fix rap!! Just change over

Re: heres a question
 

yeah, all you have to do is cut the brass tube out with a hole saw just big enough to remove it, seal up the raw wood and glass with resin or epoxy( use a small acid brush and thin the resin), then install a garboard plug over the hole with a good sealant

Re: heres a question
 

yeah, all you have to do is cut the brass tube out with a hole saw just big enough to remove it, seal up the raw wood and glass with resin or epoxy( use a small acid brush and thin the resin), then install a garboard plug over the hole with a good sealant

Re: heres a question
 

Thanks Spare...might just do that some day ;) ...

Re: heres a question
 

Thanks Spare...might just do that some day ;) ...

Re: heres a question
 

;D ;D ;D *From here on in we will refer to them as our blow holes.......lol

Re: heres a question
 

;D ;D ;D *From here on in we will refer to them as our blow holes.......lol

Re: heres a question
 

check for rot in the transom wood.......if it's turning the wood might not be stable

Re: heres a question
 

check for rot in the transom wood.......if it's turning the wood might not be stable