Can't Win
 

as you all know can't drive my boat because of my shot powerhead. well now to add to that my truck is dead not getting any power to certain fuel injectors I think it is the ECM. so now I am boatless and truckless I feel like someone cut off my testicles! :devil: does not compare to the stuff Mac Joe is going through though.


I had a very beautiful weekend here in South Florida wish I could have got out on the water

What kind of truck, year, and engine

2008 F 150 5.4 liter v8 sometimes only cylinder 5 injector isn't working sometimes the whole entire bank 2 doesn't work

Fix Or Repair Daliy FORD

X2 I have that same truck sitting outside I've redone the front end twice and replaced the manifolds on both sides + one break caliper.

are you saying the injector isn't firing because its not running correctly or have you actually checked the injector output. Those motors are known for having coil problems, and the short connector between the coil and the plug. Have you ever put plugs in it. If you are sure the injector isn't firing, disconnect the injectors and ohm each one out.

put noid test light on each only a few flashed when plugged in. so injector was not even getting signal.

FORD= found on road dead ! or fix or repair daily

I had a 2004 F-150 5.4 and was nothing but problems , 4 injectors , bad fuel pump, and 3 set's of bushings in 2.5 years !! I now drive a dodge ram 1500 NO PROBLEMS

try unplugging one injector at a time and see if the noid light shows the other ones picking up, checking resistance on each injector will show the same thing. You may have an injector shorting to ground, causing the other injectors to miss fire

Ford fans tell me it is (FIRST ON RACE DAY):sick:

FLIP OVER READ DIRECTIONS
With these distributorless ignitions the coil not only lites up the spark plugs but sends a signal to the fule injector

I am getting spark to that cylinder

ecu takes position signal from crank position sensor and cam position sensor. generally the coil driver and injector driver are separate, The ecu fires each independantly

Yes spare parts you are definitely correct on that I replaced both camshaft position sensors for s**** and giggles when It started misfiring. I have a commercial account at Advanced Auto I get them for like $10. I had another friend with this same engine that had his cam phasers fail and that was quite a mission to do. going to check wire harness for shorts before I ordered Used ecm don't really feel like having to pay to reprogram chip Keys.

pot an ohm meter on each injector

will do and post reply when I get a chance

OK had a little time this afternoon to ohm things out. all injectors 12.2 ohms and all plugs from harness 1.9 M ohms.
with key in on position i have 12 volts at all plugs from harness. SO ECM?

hello no answers no suggestions anyone

that's are far as i know, I'm not that familiar with the Ford trucks, I was just going thru basic diagnosis that I would use on any engine. I guess the next thing is to check the harness, see if the injector harness terminates to a plug that goes to the main harness. The injectors fire using a ground pulse from the ECM, so check the input wire to each injector thru the harness. See if you can find a wiring diagram on line and do a pin out resistance check from the ECM to teh injector connection. You may need to get a long jumper wire to extend you reach with the Ohm meter. It does sound like a computer taking a crap on you. Try letting the engine run, then tap on the computer with a screw driver handle and see if it changes the way the engine runs, if it does, that's a sure sign the ECM is bad

OK sounds good