Re: Cutting Aluminum
 

THANKS FOR THE OFFER OZ, AND YEAH I NEED TO SWEAT OFF A FEW - WAITIN' FOR WILLY SO WE CAN DO IT WITH 12 OZ CURLS!!!

THANKS STEVE FOR THE OFFER ALSO

Re: Cutting Aluminum
 

Yeah, Brudda...no 1st hand knowledge, buit I HEAR ::) THOSE 12 oz curls will really knock the pounds OFF!! :) ;D :) :D ;D :D ;D...

Holler if ya need to...love to see ya!!...

Re: Cutting Aluminum
 

Hey Willy, I got a Johnson 9.9 kicker. It came with the boat. Anyway, I had only used it once on the lake to motor up some skinny water to this restaurant and it did good.

This past weekend I went to the coast and used the heck out of it! I trolled flounder up little narrow creeks. At times I'd see 1.0 ft deep on the finder :o But not to worry! Trolled into the wind and current and was able to steer with the big motor no problem. Target speed was 1.8mph and was attained ;D

I opened her up to see what she'd do for the V-21 and surprisingly I got over 7mph out of it! I'm real happy with it! And, it runs like a sewing machine to be a 1975 model. I told my dad to guess what year and he said early 90's, if that tells you what condition she's in 8)

What length foot you got on that Zuki 9.9? Just my .02, but I think you will need the 20" if not already. A short shaft will likely come out of the water with ya (or get dunked).

If I run both the 9.9 and the 150 at the same time, I should be able to hit close to 50 mph, right ;D :o ???

Just kidding silly!

Re: Cutting Aluminum
 

Oh and did I mention good on gas? Its amazing how little fuel those motors use. I'm still perplexed. I ran it for probably 5 hours and couldn't tell that any fuel was missing from the original 4 gallons I put in!

Re: Cutting Aluminum
 

Hey it's a Ghost oh it's just BR forgot he was around ;D

Re: Cutting Aluminum
 

:P :P :P

You know you missed me sweetie ;) Now pucker up :-*

Re: Cutting Aluminum
 

;D ;D ;D ;D

Re: Cutting Aluminum
 

I use a 4.5" grinder or cold chisels for my non-ferrous cutting needs.