ok i will try again in a little while. the boss is wondering why i keep going outside.....lol. if it does not work i will get the code reader tonight at wally world and let you know in the morning what it comes up with.

THANKS:beer:

Chrysler Code Retrieval

Accessing Trouble Codes
96 & later are OBD2 & requires an OBD2 scanner.

Code retrieval can be accessed by the ignition key or by a diagnostic readout box(DRB).To obtain the codes using the key method,set the park brake,and put the vehicle in Park/neutral.
Some 95 and later OBDII vehicles, you may be able to retrieve OBDII codes with this procedure, if equipped with digital dash.

• Turn the ignition key ON,OFF,ON,OFF,and finally ON again(ENGINE NOT RUNNING)
• The codes will start to flash on the POWER LOSS or CHECK ENGINE light.
• FLASH,pause,FLASH,FLASH=code 12

Clearing Trouble Codes

Diagnostic trouble codes may be cleared by disconnecting the battery ground cable for at least 20 seconds.
OBD2 vehicles require a scanner to clear the trouble codes.

this may help look threw this site

http://www.troublecodes.net


Here's the codes for your Jeep

http://www.troublecodes.net/chrysler/jeep.shtml



.

thanks Skools, but the key thing did not work again. I have disconnected the battery and I will let it sit for a few hours. We will see it that clears it.


Missed you around here buddy...glad you are back:party::fam:

Yep, like the instuctions SKOOLS posted, it don't work on all of em unfortunately. I know when I was at the dealer it would get frustrating waiting on the DRBIII to read codes, but the key trick didn't work but half the time(if you were lucky).

well i just reconnected the battery after an hour and the light is OFF:fam::happy::sun:and it better stay that way:bat::bat::bat:

I give it less than a week. If you drive it almost every day.

If the light is off after a reset, then start it up. If the light doesn't come on right away then you have a problem in an OBDII monitored area. Many codes will not set until you drive it for 20 minutes at highway speeds.

i figured it will come back on.....hopefully not until I sell it:sly::zip:

Will The Check Engine Light Come On If It Is Low On Fluids Such As Transmission, Transfer Case, Power Steering, Brakefluid?

Don't think that is the case on Chrysler products. However I do know that Honda will do it. The windshield wider fluid can be low and it will set the light off.