Your work looks good. I think destroyers right though. Usually you set saw depth to cut wood but leave the bottom skin, then glue your new wood to the skin, that way it's protected underneath. I doubt much water will touch the underside of your floors, though and it should be good for 10+ years. It looks awesome!

The new plywood i installed was coated in two coats of resin and glass, the top side was coated in three coats of resin and two layers of chop glass. The bottom skin was cracked in so many places I opted to just remove the whole thing and left a two inch edge to reattach the new floor to.....it worked out quite well....

Okay, sounds like your good to go for the life of the boat then. Nice job!

Getting closer..
 

Got more done to the forward seating areas and the under console storage, and the storage under the bow area....

Got the seats done....
 

Just have sanding left and gel-coat

More pictures...
 

What do you think....

Norman GREAT Job on opening up the bow I had plans to do the same a fews years back accept i was going to open the whole bow and make it into a bowrider i just did not have the guts to do it.:nice:

I will go postal on mine someday also with a chainsaw, I will make it a bowrider with semi surround seating and storage locker below the seats is my plan.....My buddy went back to the Ukraine so no Beers and borsch so no work if you know what I mean :beer:

Awesome work not to mention your progress speed...

Getting close to done....more pics.
 

Here are some more pics....