Re: Screwin Around
 

Normally you'd wax before putting on decals and then remove the wax at the locations the decals are to go (say with alcohol).
This way you don't damage the decals after the installation by waxing. The decals (usually installed with warm water and soap) or the glue affixed stripes can be removed or adjusted easily within a week after installation (or till the adhesive sets).

Re: Screwin Around
 

Thanks T. I plan on not running the boot stripe tight to th ebottom paint this time. Gonna leave like a 1/2 gap this time. And hopefully she goes on straight too. ;D

Re: Screwin Around
 

Gives a new twist to "locked and loaded." :o

Lookin' good, hammer.

Re: Screwin Around
 

Hammer,
I notced that you have a bad case of "noassitol". More beer should help.

Re: Screwin Around
 

;D ;D ;D ;D

Re: Screwin Around
 

I think Randleman's got a case of "lookingatanothermansassisgay" ;D ;D ;D

Re: Screwin Around
 

Guess he was hoping to see Lefty's instead of mine. :P

Re: Screwin Around
 

Wanted to finish compounding today, but it looks like rain for the next couple of days. :'(



http://i47.photobucket.com/albums/f1...r/DSC03054.jpg

Re: Screwin Around
 

My fiberglass buddy stopped by to check in on me. Wasnt happy with my work. I need to wet sand more and then recompound. :-/ :'( :'( :'(

Re: Screwin Around
 

Next time he stops by, please have him put your fenders inside your original boat. Poor thing looks like she's been abandoned. Hammer, you're a LEO, isn't there some law about leaving them overboard? If so, I'd like to make a citizen's arrest. Only kidding. ;)