Wellcraft V20 Community

Wellcraft V20 Community (https://forums.wmpdevserver1.com/community/index.php)
-   Modifications (https://forums.wmpdevserver1.com/community/forumdisplay.php?f=13)
-   -   Bow Pulpit (https://forums.wmpdevserver1.com/community/showthread.php?t=19447)

Destroyer 07-25-2013 09:57 AM

Quote:

Originally Posted by RidgeRunner (Post 206606)
Thanks Destroyer, the pulpit is what I will refer to as Version 1.1. I want to do one out of pure fiberglass and a few additional contours to pretty it up. I must say it worked like a charm. The Delta is a good anchor that set very fast. I also like the ability to break it out backwards if I get it wedged somewhere. That is when the pulpit will get a real test.

The shim under the pulpit I illuded to earlier was a real time consuming PITA. 3/4" starboard 13"W x 18"L. Over the 18" it tapers from 3/4" to 1/16". Tried to contour it to the convex deck, tried without it and it just didn't look right. Easily spent 2 hours grinding on the hunk of Starboard to make it what it is. Ran completely out of time just before vacation so I got it close and thru bolted it with SS hardware. Backing plate that you can't see was 3/16"Thick 12" x 18". If the pulpit goes south I will have bigger problems than that.
I sill need to be schooled on how to make a neat road to chain splice that will fit through the deck pipe so I can put a couple extra feet of chain on without wrapping it all around the bit. So it ain't finished yet, but it is useable. I am sure some can relate..

If you know a machine shop or if you have a friend that has a Bridgeport (or any vertical) Milling machine with a large table, cutting that shim is a piece of cake. Set it on the table, clamped to the taper you want and then use a fly cutter to machine it to that taper. Whole project shouldn't take more than an hour for an experienced machinist. The setup is the hard part.. the actual cutting should take just minutes

franko 12-03-2013 08:12 PM

seeing many beautiful v20's. thought mine was alone , but much competition out there !

RidgeRunner 12-05-2013 11:53 AM

Thanks for the compliment. I like em all.

bradford 12-06-2013 09:40 AM

Quote:

Originally Posted by RidgeRunner (Post 210110)
Thanks for the compliment. I like em all.


I agree, love the beautiful owner customized ones, the one owner cream puffs in original condition, and the old salty ones.

franko 12-14-2013 11:28 AM

Hi Ridgerunner,
If you have not started your next phase of pulpit application (if that were your intention) here is a photo which is always worth ideas !
Sorry for crappy photo, and lack of.


http://i1293.photobucket.com/albums/...psa5d0f34d.jpg
EdgeWater bow deck current application….Hawse Pipe w/chain stop, Anchor Tensioner, Lewmar Delta 14 Anchor, chain w/vinyl coating ^

http://i1293.photobucket.com/albums/...ps8e83ff2b.jpg
1986 V20cc bow deck ^


My V20 equal to bow space area as viewed


All times are GMT -5. The time now is 07:29 PM.

Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.