flip it over and take a picture

there some good info for you on this Aussie
http://www.jalopyjournal.com/forum/s....php?p=3587423

yes I have been looking at that forum and joined mine had the 2 barrel intake and I saw the 2 water feeds under the intake ill have to wait till I assembly the engine and then check out all the hoses and route them how I want thinking about using the blus hoses to smarten it up :haha:

that intake you posted sure looks like a 4 barrel with a square bore adaptor

I did do some research and one of the guys said that camshafts fail lobe when there reground I have seen it happen too a lot from not running the cam in properly --not using proper cam lube --not priming the engine with oil and turning the engine over by hand too many times before start up . I saw these lifters and they seem to be a good idea but how good they are and work I don't no never pulled down a engine that has had them what you think---going to buy a set

Howards Cams Direct Lube Extreme-Duty Mechanical Lifters

there is 2 water outlets on the bottom of the manifold so when I have no water going through the intake they will do nothing thanks