When I got a new motor with a single gauge, I removed the old cracked plastic dash and threw it away. Replaced with black 1/2" starboard. Replaced all switches with a new switch panel.

If you can use a saw, a router, and a drill, or know someone who can, its a snap.

Measure three times, think about it again, measure again, cut once....

Nice looking, I didn't know that was available in black too. Hmmm.... now you have me wanting to redo mine.

Really fine work.

Has anyone done a CC (center console). Pics please.

...realize it don't fit...buy new material, doubling the cost...measure another 3 times...then one more time...cut half way, stop, measure again...realize the flange will just cover the over-cut...keep cuttin and make up something to CYA when you post yer sh!t on the board...

That's how I do it, anyway...:beer:

Starboard and a router, and you be set to go. Good luck.