Had to go out and get some updated pictures.

Wow looks like awesome progress!

great work , keep the pictures coming.

I agree with all, and I also like the starboard its a much better option!

When I made my dash I went to a boat yard and picked thur there scrap pile and got one to do the job for $10!

I then bought 3 sheets of it and did the whole boat in starboard!

http://www.wellcraftv20.com/gallery/album94

Starboard is the only way to go.

Might i suggest sealing the cut out too once you cut it, with some resin, not like its going to get waterlogged or anything, but i like every opening in my boat sealed from the elements to prevent anything from happening down the road. i plan to pass mine down to my son as my father has done to me.

More pics taken in daylight today.

Looking good. Keep us posted.

BC

I used a piece of scrap plywood sanded and stained. I put on about 8 or 9 coats of varnish and it looks great. Plus, if you screw up you're not out much, just time really. I would take your saw and trim out the extra pieces of fiberglass to make your hole in the dash square, making it easier to fit the gauges. In my opinion a speedo and fuel gauge are the two most worthless gauges on a boat.. I would have a tach, voltmeter, and water pressure for sure, maybe a water temp, and a floscan, maybe an hour meter.

I used 1/2 inch black starboard. Used circular saw & jig jaw to cut. Used a router to round over the edges. Was easy...The screws are capped with black covers ...got those at West Marine. Thats a Blue Seas switch panel and the Suzuki all in one gauge (Tach & idiot lights). Have lots of room for an indash FF/GPS...someday....

^ Yeah thats the way to do it, except i'm partial to the white.