Wellcraft V20 Community - any way to use a 20" shaft motor on a bracket that requires a 25" shaft motor?

Page 2 of 2

Show 40 post(s) from this thread on one page

Wellcraft V20 Community (https://forums.wmpdevserver1.com/community/index.php)

- General (https://forums.wmpdevserver1.com/community/forumdisplay.php?f=10)

- - any way to use a 20" shaft motor on a bracket that requires a 25" shaft motor? (https://forums.wmpdevserver1.com/community/showthread.php?t=13801)

kamikaze

04-12-2010 07:14 PM

I have one I just pulled one form my 235. If you interested let me know.

FYI: the only difference in a 506 or 507 model for OMC is the length of the rear bolt for the lower unit. You can order parts from Bay MFG if needed but each uses the same casting for the 5" extension. Nice folks at Bay, I have called them several times for help/questions and they were always very helpful, believe it's a mom and pop operation.

Kamikaze

reelapeelin

04-13-2010 12:01 PM

Quote:

Originally Posted by bigshrimpin (Post 156249)

The Bay Kit includes a

5" Shift Shaft Extension
5" Drive Shaft Extension
5" Water Tube Extension

5" Aluminum Housing (Spacer)
Longer Studs

I've used several of these kits on Motors before and they work well. The kits are $600+ . . . You can save some $$$ by finding pieces on ebay.

And they make that extension kit for almost every OB on the planet...except Honda...:cen:

All times are GMT -5. The time now is 10:34 AM.

Page 2 of 2

Show 40 post(s) from this thread on one page