Wellcraft V20 Community - Jack Plate or Not?

Page 2 of 2

Show 40 post(s) from this thread on one page

Wellcraft V20 Community (https://forums.wmpdevserver1.com/community/index.php)

- Modifications (https://forums.wmpdevserver1.com/community/forumdisplay.php?f=13)

- - Jack Plate or Not? (https://forums.wmpdevserver1.com/community/showthread.php?t=10349)

Enforcer

02-18-2009 04:24 PM

Thanks, I was looking at a 30" shaft, but i have a 25 now insteasd, but i will save the site!

cterrebonne

02-18-2009 05:12 PM

i would, also cook mfg was bought out by T & H.

reelapeelin

02-20-2009 08:10 AM

Quote:

Originally Posted by THEFERMANATOR (Post 128452)

You could always take your boat down to an aluminum welder and have him replace the rear plate on your bracket with one 5"'s taller and weld it on there. I personally would just find a 25" shaft.

Personally I like either of these routes over the jackplate idea...you got the "Mo-power-itis?"

cterrebonne

02-20-2009 11:08 AM

you can never have too much power, unless that more power is alot heavier.then you'll have issues.lol

All times are GMT -5. The time now is 10:33 PM.

Page 2 of 2

Show 40 post(s) from this thread on one page