Re: Hammer's transom Rebuild
 

Well, I did some more work on the V today. A bit more sanding and grinding. I layed in some more cloth up over teh width of teh transom, but had problems for the first time. The cloth was well wetted out, but it just wouldnt hold the form wrapping overtop of the transom. I finally cut some scrap pieces and that seemed to work. Looks like crap. Now have more sanding to do.
Also started pulling screws out and addind in some west system filler.
After that, the bugs started eating me alive. *:-/
http://i47.photobucket.com/albums/f1...r/DSC02872.jpg

Looks crappy, but she's on her way of getting reborn again. ;D

http://i47.photobucket.com/albums/f1...r/DSC02873.jpg

Re: Hammer's transom Rebuild
 

baby steps!! Looks good from my house, besides a little sanding never hurt anyone.

Re: Hammer's transom Rebuild
 

I will finish it and give you $5 ;)

Re: Hammer's transom Rebuild
 

I've always heard it was near impossible to square off corners with glass mat. I guess you proved that :-/

Hold the phone and wait for some Skools Dual advice 8)

Re: Hammer's transom Rebuild
 

4" grinder will fix the problem along with some bondo I hope. Thought about using a thinner/lighter cloth, but didnt want to loose any strenght. Hope to have her cleaned up a bit more this week.

My buddy just pulled a motor today. Guy blew it up and went with a new E-Tec. The boat has 60 gallons of 50/1 fuel that needs pumped out. It's for free, so I might be pumping out fuel for teh next day or so. ;D

Re: Hammer's transom Rebuild
 

good progress man...your gettin it! 8)

Re: Hammer's transom Rebuild
 

just needed a old coffee can to roll on it to get smooth and don't add to much cloth to thick or you will make the transom to heavy.

Re: Hammer's transom Rebuild
 

Transon Heavy ?????
Went and looked at it today. She's solid as a rock. But have some sanding ahead of me.

Re: Hammer's transom Rebuild
 

hammer, with the west system, do you have to wash the "blush" off between layers?

Re: Hammer's transom Rebuild
 

Not sure Phats. I sand between coats and clean with acetone.