Re: Specs
 

Was just now cutting the Starboard and my neighbor came up and said "if you got any leftover......" (I quickly replied) "no,ain't gonna have any leftover,gonna use it all" and smiled.
He did to.

Re: Specs
 

I was going to mount to the dash, then I hate to make more holes? But I like it on the throttle, so what I did was tape it in a few places and decided I liked it on the throttle arm, I used a wire tie and its perfect, works almost like a stock one! ;D

I am going to pick up another one soon, I hate having to get in and out the boat to tilt up and down, going to mout this one on the motor is self or transom?

Re: Specs
 

This is what you need to cut Starboard
http://i175.photobucket.com/albums/w...3/skillsaw.jpg
I (mostly) followed the instructions while ruff cutting the floor hatches and cuddy panels. When it got to the fine work of fitting out of lazyness got the battery saw out.
This thing cuts long, fine, etc, better than anything else.
The fact that it's low rpm does the trick.

Re: Specs
 

Goddamn you photobucket
Sorry guys it's getting worst
Had to get my wife to make it work.

Re: Specs
 

My table saw was perfect!! Its the Jig saw were it gets nasty, doesn't cut fast enough.

Re: Specs
 

DELAYS, DELAYS.
Told Reel possibly a couple of weeks before splashdown, well that didn't happen.
While starting to reassemble steering and other stuff, found the backboard to the steering to be too weak to support it. So I had to tear it out and replace it.
http://i175.photobucket.com/albums/w...Picture103.jpg
And not to meantion another excuse was ts Barry.

Re: Specs
 

Well at least I'm still progressing.
Got the tanks installed but not attached to the floor yet.
http://i175.photobucket.com/albums/w...Picture099.jpg

Re: Specs
 

And did like Reel and MJ said by moving the gas vent to above the rubrail.
http://i175.photobucket.com/albums/w...Picture104.jpg
In the original vent location, instead of filling the hole I just put a new one in. Hell $6 each side is easier and cheaper than fixing the holes. ;)

Re: Specs
 

Some pics so far.
http://i175.photobucket.com/albums/w...Picture098.jpg
http://i175.photobucket.com/albums/w...Picture100.jpg
http://i175.photobucket.com/albums/w...Picture101.jpg
No that red oxide color isn't staying on the glove box.
Fred brought it over with some bimini hardware. That's the original box, belive it or not!
Oh and the seats aren't for that boat.
http://i175.photobucket.com/albums/w...Picture102.jpg

Re: Specs
 

I have come to the realization that I'm not going to complete it the way I want, so I'm just going to get it to the point of "useable" to then see what changes I'll need to do.
"Splashdown" will be redefined as "test run", when that happens.