Re: Hammer's transom Rebuild
 

NO loss Hammer....scuff the heck out of what you layed up yesterday, smear a mess of resin on there and go at it ;D You'll have a good bond, then glass it all in when done. It's not gonna come out of there in your lifetime ;D

Re: Hammer's transom Rebuild
 

Look at it like this....your making a 1.5" sheet of ply....and I gaurantee that the west epoxy bonds better than whatever glue they use to make the ply.... ;)

Re: Hammer's transom Rebuild
 

Just scuff it all up good!! wet it add cloth and next piece of ply, clamp or screw toghter!

Will never come apart in the next 10 years and it won't be yours!!

Remeber to take out the screws!!

Re: Hammer's transom Rebuild
 

Ok, you guys got me motivated to try again. Going down to work on the V now. Will be back at 9pm.
camera in hand as well. ;)

Re: Hammer's transom Rebuild
 

right on Air except you don't need a layer of cloth between the outer skin and the wood. best is to do as i did for my Sea Ox i called boat manufactors asking where they buy their transom wood cause todays boats are built with 1 layer of ply wood that's 2 in thick. i bought a 40 layer 2" thick 5 x 10 sheet from a place in Greensboro NC for $98 and cut my own transom. this is where Parker and Grady buy their transoms. Itis kill dried treated. If you can buy treated that was killed afterwards it is best but higher.

Re: Hammer's transom Rebuild
 

oh and yeah Air the slower your resin sets up the better.

Hammer don't glue the camera to your hand or transom lol

Re: Hammer's transom Rebuild
 

Cloth, no cloth, cloth, no cloth. AHHHHH :-X :-X :-X
Well I sanded down the inner wood today as you guys suggested and went to town. I did wet down two scrap pieces of wood last night and they were bonded for life. Made me wonder if I realy needed cloth or not between the wood. Well I went ahead and added in a shet of cloth. With the cooler temps, it seemed that I had some longer working time. Smoking crack still helped though. :-X and I worked quick.

Re: Hammer's transom Rebuild
 

Uh, hey, big guy.......




How 'bout some freaking pix ? ;D

Re: Hammer's transom Rebuild
 

And here are some pix for all you pix HO's "Air". ;D

Hit the inside with the power grinder to scuff her up.



http://i47.photobucket.com/albums/f1...r/DSC02813.jpg

Cutting out my second piece.
http://i47.photobucket.com/albums/f1...r/DSC02814.jpg

Wetting in some cloth. Hope the cloth works. ??? ???
Skool is right about teh camera. it was sticking to my fingers. :o

http://i47.photobucket.com/albums/f1...r/DSC02815.jpg

Ahh, I did it, gotthe second piece in.

http://i47.photobucket.com/albums/f1...r/DSC02816.jpg

What a relief, I did it. 1.5 transom installed. ;D ;D
Screwed, glued and I got tattooed falling out of teh boat and landing on all my junk lying on the ground. :'(

http://i47.photobucket.com/albums/f1...r/DSC02817.jpg

Re: Hammer's transom Rebuild
 

Hey Hammer, pm me your address, I got something to send to you.